自掺杂SnO2微球的水热合成及其可见光催化性能

本研究采用水热法,以柠檬酸为螯合剂,通过控制n(Sn⁴⁺)/n(Sn²⁺)的数值,合成了由具有丰富氧空位的SnO₂纳米晶体组装成的微球。通过X射线衍射(XRD)、扫描电子显微镜(SEM)、透射电子显微镜(TEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)及UV-Vis漫反射光谱对SnO₂纳米微球进行表征分析,结果表明:在酸性水热条件和柠檬酸的螯合作用下,二氧化锡纳米晶体聚集形成微球;在Sn⁴⁺/Sn²⁺摩尔比例为3:7时,其微球尺寸最小,整体分散性较好;同时适量二价锡离子的掺杂使得该样品氧空位浓度达到最佳,氧空位的存在将使得样品光吸收范围拓展至可见光,因而该样品显示出较强的可见光催化效率,在8 min内完全降解甲基橙。     

射频等离子制备石墨烯负载Co3O4催化剂及其析氧性能研究

氢能的引入能有效提升配电网的供电可靠性,而电解水制氢是实现低碳转型的关键技术,开发高效的电解水催化剂势在必行。过渡金属氧化物储量大、催化活性高,是具有广阔应用前景的析氧反应催化剂。本文通过射频等离子体处理制备石墨烯上负载Co₃O₄析氧催化剂,XRD、Raman和XPS测试结果显示,二维结构石墨烯的引入加速表面电子迁移,增大了反应面积。等离子体处理促进了纳米粒子在石墨烯上的负载,利用等离子体刻蚀作用在催化剂表面制造出大量碳结构缺陷和氧空位结构,改善了活性位点分布,有效调控Co₃O₄电子结构,提高析氧催化活性。电化学测试表明,本文中合成的Co₃O₄@rGO在电流密度为50 mA·cm^-2时的过电位为410 mV,动力学反应速率较快,表现出优于商业IrO₂的析氧催化活性。     

New strategy for reversal tolerant anode for automotive polymer electrolyte fuel cell

New approach for the reversal tolerant anode for polymer electrolyte membrane fuel cell is suggested by using the multifunctional IrRu alloy catalyst having concurrent superior activities towards hydrogen oxidation reaction and oxygen evolution reaction to mitigate the degradation of anode under the fuel starvation condition.     

BiVO4/TiO2 heterojunction with rich oxygen vacancies for enhanced electrocatalytic nitrogen reduction reaction

The large-scale production of ammonia mainly depends on the Haber–Bosch process, which will lead to the problems of high energy consumption and carbon dioxide emission. Electrochemical nitrogen fixation is considered to be an environmental friendly and sustainable process, but its efficiency largely depends on the activity and stability of the catalyst. Therefore, it is imperative to develop highefficient electrocatalysts in the field of nitrogen reduction reaction (NRR). In this paper, we developed a BiVO₄/TiO₂ nanotube (BiVO₄/TNT) heterojunction composite with rich oxygen vacancies as an electrocatalytic NRR catalyst. The heterojunction interface and oxygen vacancy of BiVO₄/TNT can be the active site of N₂ dynamic activation and proton transition. The synergistic effect of TiO₂ and BiVO₄ shortens the proton transport path and reduces the over potential of chemical reaction. BiVO₄/TNT has high ammonia yield of 8.54 μg·h⁻¹·cm⁻² and high Faraday efficiency of 7.70% in −0.8 V vs. RHE in 0.1 M Na₂SO₄ solution.     

丹酚酸A 对H2O2 所致大鼠脑微血管内皮细胞氧化损伤保护的实验研究

目的 观察丹酚酸A 对H2O2所致大鼠脑微血管内皮细胞（RCMECs）氧化损伤的保护作用，并探讨其可能的作用机 制。方法 分离并培养大鼠脑微血管内皮细胞，用H2 O2 损伤的方法建立氧自由基损伤模型。采用丹酚酸A 进行干预后，分别测定细胞培养液中乳酸脱氢酶（LDH）活性、血栓素B2（TXB2）水平、6- 酮基前列腺素1α（6-keto-PGF1α）的含量，以及细胞内和培养液中脂质过氧化产物丙二醛（MDA）含量和超氧化物歧化酶（SOD）的活性。结果 H2O2致RCMECs 氧化损伤后，细胞LDH 释放水平、TXB2和MDA 的含量均明显增加，同时6-keto-PGF1α 含量和SOD 活性显著下降；而丹酚酸A 预处理后能呈浓度依赖性的降低RCMECs 氧化损伤后LDH 水平、TXB2含量和细胞内外的MDA 含量，提高受损细胞6-keto-PGF1α 的表达和细胞内外SOD 活性。结论 丹酚酸A 对H2O2所致RCMECs 氧化损伤具有保护作用，其机制可能与其抗氧化作用有关。     

One-step ultrasonic synthesis of Co/Ni-catecholates for improved performance in oxygen reduction reaction

The inherent periodically arranged M−N_X, M−S_X and M−O_X units (M are usually Fe, Co, Ni, etc.) in metal–organic frameworks (MOFs) can be promising active centers in electrocatalysis. In previous studies, MOFs were usually constructed by energy-consuming hydro- or solvo-thermal reactions. Ultrasonic synthesis is a rapid and environment-friendly technique when envisaging MOFs’ industrial applications. In addition, different synthetic pathways for MOFs may lead to difference in their microstructure, resulting in different electrocatalytic performance. Nevertheless, only a handful of MOFs were successfully prepared by ultrasonic synthesis and few were applied in electrochemical catalysis. Herein, we constructed Ni/Co-catecholates (Ni/Co-CATs) synthesized by one-step ultrasonic method (250 W, 40 KHz, 25 W/L, Ultrasonic clearing machine) and compared their performance in oxygen reduction reaction (ORR) with that of Ni/Co-CATs synthesized by hydrothermal method. Ni-CAT and Co-CAT prepared by ultrasonic showed the half-wave potential of −0.196 V and −0.116 V (vs. Ag/AgCl), respectively. The potentials were more positive than those prepared by hydro-thermal method. And they showed excellent electrochemical stability in neutral solution. The latter was only 32 mV lower than that of commercial Pt/C. The improved performance in ORR was attributed to higher specific surface area and mesopore volume as well as more structural defects generated in the ultrasonic synthesis process, which could facilitate their exposure of electrocatalytic active sites and their mass transport. This work gives some perspective into cost-effective synthetic strategies of efficient MOFs-based electrocatalysts.     

Activation of α-Fe2O3 for Photoelectrochemical Water Splitting Strongly Enhanced by Low Temperature Annealing in Low Oxygen Containing Ambient

Photoelectrochemical (PEC) water splitting is a promising method for the conversion of solar energy into chemical energy stored in the form of hydrogen. Nanostructured hematite (α-Fe₂O₃) is one of the most attractive materials for a highly efficient charge carrier generation and collection due to its large specific surface area and the short minority carrier diffusion length. In the present work, the PEC water splitting performance of nanostructured α-Fe₂O₃ is investigated which was prepared by anodization followed by annealing in a low oxygen ambient (0.03 % O₂ in Ar). It was found that low oxygen annealing can activate a significant PEC response of α-Fe₂O₃ even at a low temperature of 400 °C and provide an excellent PEC performance compared with classic air annealing. The photocurrent of the α-Fe₂O₃ annealed in the low oxygen at 1.5 V vs. RHE results as 0.5 mA cm⁻², being 20 times higher than that of annealing in air. The obtained results show that the α-Fe₂O₃ annealed in low oxygen contains beneficial defects and promotes the transport of holes; it can be attributed to the improvement of conductivity due to the introduction of suitable oxygen vacancies in the α-Fe₂O₃. Additionally, we demonstrate the photocurrent of α-Fe₂O₃ annealed in low oxygen ambient can be further enhanced by Zn-Co LDH, which is a co-catalyst of oxygen evolution reaction. This indicates low oxygen annealing generates a promising method to obtain an excellent PEC water splitting performance from α-Fe₂O₃ photoanodes.     

Electrocatalysis in confined space

The complex interplay of restricted mass transport leading to local accumulation or depletion of educts, intermediates, products, counterions and co-ions influences the reactions at the active sites of electrocatalysts when electrodes are rough, three-dimensionally mesoporous or nanoporous. This influence is important with regard to activity, and even more to selectivity, of electrocatalytic reactions. The underlying principles are discussed based on the growing awareness of these considerations over recent years.     

Strategies for Improving the Catalytic Performance of 2D Covalent Organic Frameworks for Hydrogen Evolution and Oxygen Evolution Reactions

Hydrogen evolution reaction (HER) and oxygen evolution reaction (OER) have been deemed as clean and sustainable strategies to solve the energy crisis and environmental problems. Various catalysts have been developed to promote the process of HER and OER. Among them, two-dimensional covalent organic frameworks (2D COFs) have received great attention due to their diverse and designable structure. In this minireview, we mainly summarize the diverse linkages of 2D COFs and strategies for enhancing the catalytic performance of 2D COFs for HER and OER, such as introducing active building blocks, metal ions and tailored linkages. Furthermore, a brief outlook for the development directions of COFs in the field of HER and OER is provided, expecting to stimulate new opportunities in future research.